Crankcase Cover Assembly

1. Place the Crankcase Cover back into the appropriate position, ensure that the proper gasket is in place as well. Slide the cover on so that it properly aligns with the two locating pins.
2. Replace the seven Crankcase Cover 3/8" and tighten them by hand. The bolts must tightened using the torque wrench to 85 in - lbs or 7 ft - lbs, in a star sequence, follow the numbers on the diagram below for the correct bolt tightening sequence. Tighten the bolts in 3 stages using the sequence shown. The first stage should be up to approximately 30 in-lb. and second should be up to 60 in-lb. and then firmly to 85 in-lbs. This will prevent and warping or deformation of the cover.